Fits all 10th Generation 1.5L Turbo Civic Models. In collaboration with Hondata, Spoon has been developing the 1.5L turbocharged L15 engine. At Time Attack testing, the FK7 demonstration car with updated ECU settings, was able to better the standard FK8 TYPE R lap time. However, it felt like it was not enough power and torque to outpace the higher horsepower K20C engine. Analysis of the HONDATA ecu logs, show that the increased boost pressure and power output results in higher exhaust temperature and pressure, this eventually makes the turbocharger reach its maximum capacity. As the fuel system of the L15 Turbo engine has sufficient capacity, Spoon has determined that it is possible to further improve the output by developing an all-new large capacity turbocharger capable of producing more boost pressure. Turbocharger technology has rapidly evolved to meet strict fuel consumption standards, exhaust gas regulations and there are many manufacturers. With this in mind, the newest and the most beneficial turbocharger from MHI was chosen for its advanced technologies. After several months of development, the Spoon Big Turbocharger Kit is introduced. The result is increased high rpm range output and improved medium to low torque. The housing has the same shape with the original turbocharger; therefore, it does not require any additional parts to install, just bolt it on and it’s ready. The new Spoon Big Turbocharger Kit features: larger compressor and turbine wheels, changes to the number of blades on the turbine wheel and optimized design to improve efficiency. Spoon FK7 Demo Car Spoon Turbo 42.17Kgm (305 ft lb) Factory Turbo 23.25Kgm Spoon Turbo 274.73ps (221.65hp) Factory Turbo 166.38ps When Used together with Hondata FlashPro, (not included) the Spoon Big Turbocharger can increase torque by 19Kgm (137 ft lb) and power by 108ps (106 hp) over stock. *Caution! Higher capacity clutch required. SPEC Compressor Wheel Inlet Diameter: 34.9mm (Std 39.1mm) Outlet Diameter: 49mm (Std 46mm) Wheel Diameter: 49mm (Std 46mm) Number Of Turbine Blades: 12 (Std 12) Turbine Wheel Inlet Diameter: 40mm (Std 37mm) Outlet Diamter:36.7mm (std 32.5mm) Wheel Diameter: 40mm (Std 37mm) Number Of Turbine Blades: 9 (Std 11)
